jnjsyj
Open/Open
  
Age : 38
Joined : 14 Nov 2007
Posts : 8
Localisation : Bel Air MD
|  Subject: flange adapter for 8.8  Fri Mar 07, 2008 9:58 pm | |
| | Where do i get a flange adapter for a 8.8 so i can install it in a yj |
|
Chris Taylor
Locker/Spool
Age : 38
Joined : 07 Feb 2007
Posts : 329
Localisation : Forest Hill
| | Subject: Re: flange adapter for 8.8 Fri Mar 07, 2008 10:18 pm | |
| | Got mine from M.O.R.E |
|
makitupthehardway
moderator
Age : 26
Joined : 19 Jan 2007
Posts : 1378
Localisation : Ashburn, VA
| | Subject: Re: flange adapter for 8.8 Fri Mar 07, 2008 11:01 pm | |
| x2
_________________
2008 ADA run - Trail Master (all questions welcome)
94YJ locker/spool, lifted 37" MTR's lots of cool stuff (Trail rig)
00WJ open/open, lifted 31" MTR's (curbcrawler)
84 Toyota Pickup open/welded, 33's solid front axle and rusted frame
07 FORD E350 SD (TOW VAN)
KARNAGE MOTORSPORTS INC.[b] |
|
Rockn93YJ
Locker/Spool
 
Age : 40
Joined : 20 Jan 2007
Posts : 1253
Localisation : Knoxville, MD
| | Subject: Re: flange adapter for 8.8 Sat Mar 08, 2008 10:01 am | |
| | I bought one from currie for my 9" |
|
Rockn93YJ
Locker/Spool
Age : 40
Joined : 20 Jan 2007
Posts : 1253
Localisation : Knoxville, MD
| | Subject: Re: flange adapter for 8.8 Sun Mar 09, 2008 9:21 am | |
| http://www.marylandjeepclub.org/phpBB3/viewtopic.php?f=12&t=11136
I have a barely used Spicer flange yoke to allow a 1310 series u-joint to bolt to the 8.8 flange (I believe the Spicer part# is 2-2-1379). I bought this and used it for maybe 50 miles before swapping my stock driveshaft out for an Explorer one. $15
Also, I have the flanged CV centering yoke from a 95? Explorer rear driveshaft. Allows the 1310 CV to bolt to whatever the flanged t-case output on the explorer is. - FREE
Stock 98 XJ (AX-15/231)rear driveshaft with slip yoke. 29" between u-joint centers. Should be a little longer than the stock auto shaft, maybe good for a lift? - FREE
Stock Front Driveshaft for 1980 258/304 automatic - 32.75" collapsed, 35.75" extended, 1.25" diameter to fit past transmission pan, fits 1310 series u-joints. Both u-joints need to be replaced, otherwise good condition - $30 |
|
