Ring and Pinion

SLeach · Subject: Ring and Pinion Sun Jun 07, 2009 12:16 am

This is more of a feeler at this point.

I need either 3.73 or 4.10 ring and pinion for a dana 30 reverse rotation. I am swapping in a 8.8 over the summer along with a new transmission so i need a lower gear ratio.

Thanks,
Sean

makitupthehardway · Subject: Re: Ring and Pinion Mon Jun 08, 2009 12:14 am

Sean I have a built Dana 30 with 4:10's that has your name all over it. comes with 2 sets of steering hardware, warn lockout hubs, detroit locker one piece XJ shafts(might need new ones but good for spares) Its out of my 94 YJ is it can bolt in to yours. I have rotors to go with it but not sure where the calipers went. Send me a PM and we can talk money or trade.

_________________
94YJ Tera low 4:1, 4:10's, HP D44 front locked, 8.8 rear locked, 37" Truxus M/T's, custom spring over front/spring under rear, along with other stuff (Trail rig)
00WJ open/open, lifted 31" MTR's (curbcrawler)
84 Toyota Pickup open front, welded rear, 63" chevy rear springs, propane injection, 37" mtr's, 4.7:1 Tcase
07 FORD E350 SD (TOW VAN)

Proud member of MARR (if you don't get it don't ask, it will ask you)