np231

Subject: np231 Thu Jun 30, 2011 5:33 pm

Let me know if anyone happens to have their old stock transfer case laying around or if you see one for sale on a board somewhere. Sounds like my Dad's blew up today in his '94 YJ (6cyl, 5spd). He thinks the u-joint at the rear pinion let loose and the driveshaft spun wild and screwed up the transfer case.
Thanks!
Dan

Subject: Re: np231 Thu Jun 30, 2011 11:26 pm

I went over and looked at it tonight after work and the cone shaped part (Where the SYE would go) that bolts to the back half of the transfer case cracked all the way around and sprayed the ATF everywhere. The driveshaft itself looks OK. He'll need to replace both u-joints, the yoke on the D35 and its straps, the muffler.

I found a np231 in Frederick for $75 that I'll pick up this weekend.

Subject: Re: np231 Tue Jul 05, 2011 10:26 pm

There is a chance I have those parts in my collection somewhere. I will look after work tomorrow and see what I find.

Subject: Re: np231 Wed Jul 06, 2011 12:06 am

Thanks Nester.
Just looking for the yoke now - he bought the t-case last weekend. I'll look around at the junk piles at the york jeep show coming up for one if you don't find your old one.

Subject: Re: np231 Wed Jul 06, 2011 10:40 pm

Danny I should have one at the house let me look for it and I tell you for sure

Subject: Re: np231 Wed Jul 06, 2011 10:54 pm

Danny found two let me know when you want to stop by to get one if you straps let me know they are in the jeep as spare parts for others.

or I can drop it off to your house

Subject: Re: np231 Wed Jul 06, 2011 11:36 pm

Thanks Paul,
I can stop by one night after work - whatever day works for you. Let me know how much I owe ya!

Subject: Re: np231 Thu Jul 07, 2011 6:19 am

Fri is fine I will be loading up to go wheeling this weekend. this should work it's the right spline count but I keep reading that you need a speical seal this yoke is off a dana 300 you will have to used the dust shield off yours. and it's free

Subject: Re: np231 Thu Jul 07, 2011 7:35 am

Awesome - Thanks!
We were going to put a new pinion seal in there anyway - so that will work out fine.
Would about 5:30 tomorrow afternoon be OK? Depending on traffic that is usually the time I get back up here after work. Can you PM me your address?
Thanks!
Dan

Subject: Re: np231 Thu Jul 07, 2011 7:53 am

connordanny wrote:: Awesome - Thanks!
We were going to put a new pinion seal in there anyway - so that will work out fine.
Would about 5:30 tomorrow afternoon be OK? Depending on traffic that is usually the time I get back up here after work. Can you PM me your address?
Thanks!
Dan

that will work fine see you then